The Duck Brand’s Max Roll-On Window Kit creates an added barrier between the outdoor air and your home’s inside. This helps block drafts and air leaks that lead to high heating costs.

Plastic window insulation kits can save energy on both heating and cooling and lower your utility bills by providing an insulating barrier of trapped air and keeping out any drafts.

To install plastic window insulation kits:

  1. Clean the surfaces on the window casing.
  2. Apply double-sided tape to the window casing around the perimeter of the inside of the window.
  3. Remove the paper backing on the tape.
  4. Spread out the sheet of plastic and attach it to the tape with as few wrinkles as possible.
  5. Use the heat from a hair blow dryer to shrink the plastic for a tight fit.

Watch this video to find out more.

Further Information

VIDEO TRANSCRIPT
The first step in applying a window insulating kit is cleaning the surfaces where it will be attached. Next, you apply the two-sided tape that comes with kits around the entire perimeter of the window. Once you remove the backing on the tape, you’re ready to spread out the clear plastic film and attach it to the tape.

It can be pulled off and repositioned if necessary, but it’s best to get it lined up before you begin attaching it. Even though you want to stretch as tight as possible, there will still be wrinkles that obscure your view, so the final step is heat the plastic with an ordinary blow dryer. As the plastic heats up it will shrink, removing the wrinkles and preserving your view while it seals your window.

4 COMMENTS

  1. The windows in our apartment are drafty and the winters feature high wind that inevitably burst the plastic at the seams. We have been using mailing tape as an additional reinforcement but that inevitably peels the paint. Do you have an alternate recommendation that would be gentler on the paint than mailing tape to prevent peeling on removal, and would in general to be easy to remove without marking or staining the tape?

    Thank you,

    Robert Ferguson

  2. We have tried for two years now to put plastic over our large picture window. Each year the plastic pops off from the tape.
    Is there a solution to this?

LEAVE A REPLY

Please enter your comment!
Please enter your name here