This week, hear how to replace two small windows with a large one and learn why cold weather can make propane less effective. (PC Photography, Getty Images/gmnicholas, Getty Images Signature)

Note: Audio from the latest episode of “The Today’s Homeowner Radio Show” is available Sundays after 4 p.m. CST.


Hour 1 

Hear how to install laminate flooring around a door jamb, repair cracks in plaster and more. 


Installing Laminate Flooring Around Door Jambs

Reciprocating saw on top of laminate flooring with saw dust
To install laminate flooring around door jambs, you’ll need to trim the jamb with a saw so the flooring can slip under it. (Ocskaymark, Getty Images)

A homeowner asks: “How do you cut laminate flooring to fit neatly around door jambs in a cased opening between two rooms?”

Here’s the thing: Most of the time, you’re not cutting the flooring; you’re actually cutting the bottom of the jamb where it hits the floor.

A tool called a jamb saw is perfect for doing this. It’s like a circular saw, but the blade is turned 90 degrees so you can easily slide it into the jamb. You can rent one of these from a home center.

If you don’t want to rent a jamb saw, you can take a scrap piece of the flooring and put it on the subfloor against the jamb to get its exact height. If there’s any type of underlayment that goes under the laminate flooring, put that under it as well. 

Then, use a reciprocating saw or a hand saw to cut a little bit off of the jamb so the flooring can slip under it. The thickness of the blade should leave enough room for the laminate flooring to expand and contract.

Watch: How to Install Laminate Flooring


Fixing Cracks in a Plaster Wall

Crack in beige plaster wall
If you see a crack in your plaster, don’t panic! Small cracks can be repaired fairly easily. (Courtesy of Wes Burchell)

“What’s the best way to repair this old plaster wall?

Working with plaster is a little like working with drywall, but the final finish can be tricky to match.

The first thing you need to do is scrape out the crack using the pointed tip of a can opener. What you’re doing is widening that crack into a v-shaped opening to hold more plaster compound. Make it at least a quarter-inch wide. 

Then, vacuum the dust out of the crack and clean the surface around it with a damp towel to remove any dust.

Then, you use joint compound or patching plaster to fill in the crack.

Once the crack is patched, prime and paint it to match the rest of the wall. With any paint repair, don’t just paint the repair area. Spread the paint out at least a couple of feet in each direction. 

Watch: How to Repair Cracks in Plaster Walls


Hour 2

Hear a caller’s Simple Solution suggestion: how to replace two small windows with a large one, and more. 


Simple Solution Suggestion 

Split image of effervescent tablets dissolving in water and tap water flowing down the drain
The effervescent action of denture tablets loosens buildup in a drain and makes it easier to flush away. (LdF, Getty Images Signature/laymul, Getty Images)

Diane McClaskey in Missouri has a Simple Solution suggestion for cleaning a sink drain.

After removing the pop-up stopper, add six to eight denture cleaning tablets to the drain, and add just a little water. Wait to let the cleaning begin, and add a little water as needed until clean. 

The effervescent action will help to break up any dirt or grime and leave your sink sparkling clean!

So why would this work? The main ingredient in denture cleaning tablets is sodium bicarbonate, commonly known as baking soda.

This works similarly to our Easy Way to Clean and Deodorize Your Sink Simple Solution.


Replacing Two Small Windows with a Large One

Simple home office with large window
Replacing two small windows with a large one is a great way to let in more light and improve your home’s curb appeal. (PC Photography, Getty Images)

A homeowner wants to replace two small windows with a larger one in her living room.

However, there’s a 6-inch wall between the windows, and she was told she needed to put in a header — now, she’s stumped.

“I don’t know how to do this. Can you explain, please?” she asks.

When you take a window out, you need to replace it with something to fill that void. A header, basically, is a 2-by-4 to a 2-by-12 that spans horizontally above the window to support its weight. This prevents the ceiling joists, roof rafters, and anything above that might be bearing down on the window from sagging.

However, it’s a tricky project.

First, you have to access that area, and that’s done by cutting the drywall or plaster away from the inside above the upper part of the window opening so you’ll have room to cut out whatever’s there and put in the new beam. 

Unless you’re very good at carpentry work, I suggest calling a professional to do this. The last thing you want is any sagging on the window down the road. 

A professional can also ensure the new window is sealed properly to avoid drafts and energy loss.

Call your local home builder’s association and ask for their recommendations. 


Can Low Temps Damage a Propane Tank?

Propane tank against wooded background
Low temperatures can make propane less effective. (gmnicholas, Getty Images Signature)

We receive this question a lot during the fall and wintertime.

A homeowner says: “I have a backup propanse tank that I store in my garage. It’s been there for over a year. Now, I can’t get my grill to start with it. Does storing the tank for that long in a cold garage damage it?”

Here’s what you should know: To keep propane in a liquid state, it has to be stored under pressure. Low temperatures can cause liquid propane to condense, which can then decrease the pressure inside the tank.

This can eventually lead to the pressure in the propane tank reaching a point where it is too low to effectively light a grill or other appliances.

Here’s the solution: Bring the propane tank inside and let it warm up. Then, check the level of gas. When in doubt, refill the tank! 

In the future, to keep the pressure higher, keep the tank at least 30 percent full at all times, and use a small insulated frame shelter to protect the tank from lower temperatures.


Best New Products

MSI’s new peel-and-stick backsplash gives you the look of real tile without all the hassle of a traditional thin-set application. Learn more >>

Simple Solutions

Drill holding a spool of mason line/nylon string by a screw inserted into the handle
Using a power drill to wrap nylon string around a spool will speed up the process and lessen the likelihood of tangles. (3 Echoes Content Studio)

Fast and Neat Way to Wind String onto a Spool — A spool of nylon string can be used for many things — general crafting, fishing and hunting, and laying mason lines.

The string is easy to unwind off the spool, but it’s not as easy to get back on after you’ve used it. Winding it by hand back onto the spool can lead to tangles and uneven distribution. And eventually, you’ve got an unusable mess that you have to cut up. Here’s a much better, and faster, solution: 

  • Take a screw and drive it through the end of the plastic housing that the spool is on. Then, chuck it into a drill. 
  • Turn on the drill to the lowest setting, and just like that, you can now use the power of the drill to put the line back on the spool. 

It only takes a few seconds to wind the nylon string back onto the spool! As you’re winding up the nylon string, slowly move it back and forth along the spool. This way, you don’t overload one side or the other, and the string winds up neatly every time.

Watch: The Fast (and Neat!) Way to Wrap String Around a Spool

Hand pouring Clorox toilet bowl cleaner gel into grout lines on a bathroom floor
A toilet bowl cleaner’s spout makes it perfect for pouring into grout lines. (3 Echoes Content Studio)

Inexpensive Alternative to Commercial Grout Cleaners — If you have tile in your home, chances are you’ve spent some time cleaning grout. While there are several grout cleaning products on the market, you might have something in your home right now that works just as well — toilet bowl cleaner. 

Regular old toilet bowl cleaner that comes in a squeeze bottle can clean grout! Toilet bowl cleaner contains bleach, so it will not only lighten grout stains, but it will also kill any mold or mildew.

Plus, toilet bowl cleaner is cheaper than grout cleaner.

Watch: Toilet Bowl Cleaner: The Inexpensive Alternative for Cleaning Grout


Products and Links Mentioned

This page contains affiliate links. If you purchase a product from these links, we will earn a small commission at no additional cost to you.


Radio Show & Podcast: Send us your question!

If you have a home improvement question, call us at 1-800-946-4420 or fill out this form and we will get back to you:

"*" indicates required fields

Location*
Drop files here or
Accepted file types: jpg, jpeg, gif, mov, avi, png, mp4, Max. file size: 100 MB.
    Add up to 80Mb of images and/or video to better illustrate your question.
    Subscribe to Tips for Today's Homeowner
    This field is for validation purposes and should be left unchanged.
    Editorial Contributors
    avatar for Danny Lipford

    Danny Lipford

    Founder

    Danny Lipford is a home improvement expert and television personality who started his remodeling business, Lipford Construction, at the age of 21 in Mobile, Alabama. He gained national recognition as the host of the nationally syndicated television show, Today's Homeowner with Danny Lipford, which started as a small cable show in Mobile. Danny's expertise in home improvement has also led him to be a contributor to popular magazines and websites and the go-to source for advice on everything related to the home. He has made over 200 national television appearances and served as the home improvement expert for CBS's The Early Show and The Weather Channel for over a decade. Danny is also the founder of 3 Echoes Content Studio, TodaysHomeowner.com, and Checking In With Chelsea, a décor and lifestyle blog.

    Learn More